Ameeha Guard Boiling Milk Alarm

Product Details:

• Put Milk container on gas for boiling as it is done normally.
• Open the folding Wire supports of Milk Guard and place it on the container as shown in the picture 
• The sensor tube should dip by at least half inch in the milk. If quantity of milk is less, than use a smaller container so that sensor dips properly. 
• Switch on the toggle switch of milk guard- A green LED will glow and you'll hear a beep. Milk Guard is now working and you are free to do any other work.. it emits single beep after every 3 minutes to assure you that it is working properly. 
• When about 1 minute is left for the mil to boil, Milk guard will start giving continuous beeps. Now you should be ready to move to the kitchen. After few seconds later, The beeps become faster and the milk is almost ready to boil. 
• Switch off the device and remove it from container, well before the milk boils. 
• Put off the gas burner when the milk has boiled. Wipe clean or wash the sensor tip by holding it downwards and keep it safely for next use.